Example For Configuring The Ftp Download Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.35.2 Example for Configuring the FTP Download Test

Networking Requirements
As shown in
l
l
Figure 6-4 Networking diagram for configuring the FTP download test
FTP Client
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the IP addresses of Switch A and Switch B. The configuration details are not
mentioned here.
Step 2 Configure Switch B as the FTP server.
<SwitchB> system-view
[SwitchB] ftp server enable
[SwitchB] aaa
[SwitchB-aaa] local-user user1 password cipher hello
[SwitchB-aaa] local-user user1 service-type ftp
[SwitchB-aaa] local-user user1 ftp-directory cfcard:
[SwitchB-aaa] quit
Step 3 Configure an NQA FTP test on Switch A.
<SwitchA> system-view
[SwitchA] nqa test-instance admin ftp
Issue 01 (2012-03-15)
Figure 6-4:
Switch B functions as the FTP server.
A user with the name user1 and the password hello intends to log in to the FTP server to
download the test.txt file.
SwitchA
GE1/0/0
VLANIF10
10.1.1.1/24
Configure Switch A as the NQA client.
Create and perform the FTP test on Switch A to check whether a connection between
Switch A and the FTP server can be set up and to check the time for downloading a file
from the FTP server.
IP address of the FTP server
Source IP address for the test
FTP user name and password
Operation file of the FTP test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE1/0/0
VLANIF10
10.1.1.2/24
6 NQA Configuration
385