Huawei S9300 Configuration Manual page 279

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other ICMP test parameters ( For
detailed parameter configurations, see the chapter
Parameters
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source interface that sends test packets, run the source-interface interface-
l To configure the source IP address, run the source-address { ipv4 ip-address | ipv6 ipv6-
l To configure the size (packet header excluded) of the Echo-Request packet, run the
l To configure the time-to-live (TTL) value, run the ttl number command.
l To configure the type of service (ToS) field in the IP packet header, run the tos value
l To configure padding characters, run the datafill fillstring command.
l To configure the interval for sending the test packets, run the interval seconds interval
l To configure the percentage of the failed NQA test, run the fail-percent percent command.
l To configure the NQA test packets to be sent without searching the routing table, run the
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
Issue 01 (2012-03-15)
):
command.
type interface-number command.
address } command.
source-address { ipv4 ip-address | ipv6 ipv6-address } equals the "-a" option in the ping
command.
datasize size command.
datasize size equals the "-s" option in the ping command.
ttl number equals the "-h" option in the ping command.
command.
tos equals the "-tos" option in the ping command.
datafill equals the "-p" option in the ping command.
command.
interval seconds equals the "-m" option in the ping command.
sendpacket passroute command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuring Universal NQA Test
6 NQA Configuration
264