Example For Configuring Nqa Upper/Lower Alarm Threshold And Test Instance Linkage - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.28 Example for Configuring NQA Upper/Lower Alarm
Threshold and Test Instance Linkage
This part provides examples for configuring the association of NQA test instances to dynamically
monitor faults on the network.
Networking Requirements
As shown in
Switch A and Switch B. If the packet loss ratio in the test result exceeds the threshold, the linking
test instance is triggered to test whether Switch B is reachable.
Figure 6-30 Networking diagram of configuring the NQA alarm threshold and test instance
linkage
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Enable the NQA client and create an NQA ICMP test instance.
<SwitchA> system-view
[SwitchA] nqa test-instance admin icmp
[SwitchA-nqa-admin-icmp] test-type icmp
[SwitchA-nqa-admin-icmp] destination-address ipv4 11.1.1.2
[SwitchA-nqa-admin-icmp] quit
Issue 01 (2012-03-15)
Figure 6-30, an NQA Jitter is required to monitor the packet loss ratio between
GE1/0/0
VLANIF10
11.1.1.1/24
GE1/0/0
VLANIF10
11.1.1.2/24
Configure Switch A as the NQA client and Switch B as the NQA server.
On the NQA client, configure the type of the linking test instance to be ICMP.
On the NQA client, specify the event that triggers test instance linkage.
On the NQA client, create an ICMP Jitter test instance, as a primary test instance.
On the NQA client, configure the alarm threshold.
On the NQA client, start the primary test instance.
Index of the linking test instance
Number of the event associated with the threshold
Number of the alarm threshold
Upper threshold and lower threshold
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
6 NQA Configuration
474