Example For Configuring The Jitter Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
l

6.35.10 Example for Configuring the Jitter Test

Networking Requirements
As shown in
transmitting a packet from Switch A to Switch C. Switch A and Switch C synchronize the clock
from Switch B so that the test precision is improved.
Issue 01 (2012-03-15)
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin udp
test-type udp
destination-address ipv4 10.2.1.2
destination-port 6000
#
ip route-static 10.2.1.0 255.255.255.0 10.1.1.2
#
return
Configuration file of Switch B
#
sysname SwitchB
vlan batch 100 110
#
interface Vlanif100
ip address 10.1.1.2 255.255.255.0
#
interface Vlanif110
ip address 10.2.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
nqa-server udpecho 10.2.1.2 6000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-12, the NQA Jitter test needs to be used to obtain the jitter time of
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
401