Configuring The Protocoldirtable; Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
If an interface that corresponds to the hlHostControlDataSource in an entry is deleted, the entry
is deleted at the same time.
----End

8.4.3 Configuring the ProtocolDirTable

RMON2 can collect only the IP packet statistics on Ethernet interfaces.
Context
Do as follows on the switch that is monitored.
Procedure
Step 1 Run:
system-view
Step 2 Run:
rmon2 protocoldirtable protocoldirid protocol-id parameter parameter-value [ descr
description-string ] [ host { notsupported | supportedon | supportedoff } ]
[ owner owner-name ] [ status { active | inactive } ]
The protocolDirTable is configured.
The RMON2 supports the traffic statistics of IP packets only on Ethernet interfaces. Since a
single protocol corresponds to an entry, this table currently has only one entry.
l When an entry is created or the entry status (protocolDirStatus) is set to active, both
l When the protocolDirStatus is set to active, the value in the protocolDirDescr cannot be
l When the protocolDirStatus is set to inactive, the corresponding entry in the hlHostTable is
----End

8.4.4 Checking the Configuration

After configuring RMON2, you can view the traffic statistics collected by RMON2.
Prerequisites
The configurations of the RMON2 are complete.
Issue 01 (2012-03-15)
parameter (equivalent to protocolDirDescr) and host (equivalent to
protocolDirHostConfig) must be set at the same time.
changed.
– If the protocolDirHostConfig value is notsupported, it cannot be changed into other
values.
– If the value is not notsupported, it can be switched between supportedon and
supportedoff.
– When the protocolDirHostConfig value changes from supportedon to supportedoff, the
corresponding entry in the hlHostControlTable is deleted.
deleted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 RMON and RMON2 Configuration
544