Introduction To Nqa; Comparisons Between Nqa And Ping - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.1 Introduction to NQA

This section helps you understand the background and functions of Network Quality Analysis
(NQA).
As the value-added services on networks are developed, users and carriers demand higher
Quality of Service (QoS). To ensure users with the committed bandwidth, network operators
should collect the statistics of latency, jitter, and packet loss of the device. This helps them
analyze network performance in time.
NQA on the S9300&S9300E meets the preceding requirements.
NQA measures the performance of each protocol running on the network and helps network
operators collect network operation statistics, such as the total HTTP delay, TCP connection
delay, file transfer rate, FTP connection delay, Domain Name System (DNS) resolution delay,
and DNS resolution error ratio. By collecting these statistics, network operators provide users
with network services of various grades.
NQA is an efficient tool for diagnosing and locating faults on a network.

6.2 Comparisons Between NQA and Ping

This part describes the differences between NQA and Ping tests.
NQA is the extension and enhancement of Ping.
By sending an Internet Control Message Protocol (ICMP) Echo-Request packet from the local
and expecting an ICMP Echo-Reply packet from the specified destination, the Ping program can
test the round-trip time (RTT) of an ICMP packet. In addition to testing the RRT of an ICMP
packet between the local and the desination, NQA can detect whether network services, such as
TCP, UDP, FTP, HTTP and the Simple Network Management Protocol (SNMP), are enabled
and test the response time of each service.
Figure 6-1 Diagram of the NQA test
NQA Client
In NQA, the RTT of each packet or timeout period of the packet is not displayed on the terminal
in real time, unlike the Ping program. Test results are displayed only when you run the display
nqa results command after a test is complete.
You can also configure the Network Management System (NM Station) to control each NQA
operation parameter and enable NQA tests.
Issue 01 (2012-03-15)
Server
IP/MPLS
Network
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
260