Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
test-type test-type
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
threshold rtd rtd-value
The round-trip transmission delay threshold is configured.
Step 7 Run:
send-trap rtd
The trap function is enabled.
----End

6.29.3 Checking the Configuration

After setting the round-trip transmission delay threshold, you can view the configuration.
Prerequisites
The configurations of the Round-Trip Delay Thresholds Test function are complete.
Procedure
Step 1 Run the display nqa-agent [ admin-name test-name ] [ verbose ] to view the status of the test
instance configured on the NQA client.
----End
Example
Run the display nqa-agent verbose command. If the test is successful, the following is
displayed. For example:
<Quidway> display nqa-agent verbose
NQA Tests Max:2000
NQA Flow
Issue 01 (2012-03-15)
NQA Tests
Max:1000 NQA Flow Remained:1000
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Number: 1
6 NQA Configuration
364