Huawei S9300 Configuration Manual page 474

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

Figure 6-26 Networking diagram for configuring the PWE3 Trace test on a multi-hop PW

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Issue 01 (2012-03-15)

100.1.1.1/24

Run the IGP protocol on the backbone network to make the routes between Switches on

the backbone network reachable.

Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.

Set up MPLS LDP peer relations between U-PE1 and S-PE, and between U-PE2 and S-

Create an MPLS L2VC connection between the two U-PEs.

Create a switching PW on the switching node S-PE.

Configure a PWE3 Trace test on the multi-hop PW on U-PE1.

L2VC IDs on U-PE1 and U-PE2, which must be different

MPLS LSR-IDs of U-PE1, S-PE, and U-PE2

IP address of the remote peer

Encapsulation type of the switching PW

Name and parameters of the PW template on U-PE devices

Huawei Proprietary and Confidential

6 NQA Configuration

100.1.1.2/24