Huawei S9300 Configuration Manual page 580

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Figure 9-3 Traffic distribution based on the Eth-Trunk
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure an Eth-Trunk, add member interfaces to the Eth-Trunk, and set the load balancing
mode.
# Create Eth-Trunk 1, and add GE 1/0/1, GE 1/0/2, GE 1/0/3, and GE 1/0/4 to Eth-Trunk 1.
<Quidway> system-view
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] interface eth-trunk 1
[SwitchA-Eth-Trunk1] trunkport gigabitethernet 1/0/1 to 1/0/4
# Configure load balancing based on traffic classification and monitoring on Eth-Trunk 1.
Issue 01 (2012-03-15)
SwitchB
SwitchA
GE 1/0/1
GE 1/0/2
Server 1 Server 2
Configure an Eth-Trunk and set the load balancing mode.
Configure a traffic policy and apply the traffic policy to the inbound interface connected
to the optical splitter.
Configure unidirectional single-fiber communication.
Number of the ACL rule
Eth-Trunk and member interface numbers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Upstream
Traffic Splitter
SwitchC
XGE 2/0/1
GE 1/0/4
Eth-Trunk 1
GE 1/0/3
Server 3 Server 4
9 Traffic Distribution Configuration
565