Collecting Ipv4 Traffic Statistics; Establishing The Configuration Task; Configuring The Netstream Function On An Interface - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

7.3 Collecting IPv4 Traffic Statistics

This section describes how to collect statistics about IPv4 traffic passing through an interface.

7.3.1 Establishing the Configuration Task

Applicable Environment
You need to configure the NetStream on an interface to collect statistics about inbound and
outbound IPv4 packets respectively. The statistics result is sent to the Network Management
System (NMS). By analyzing the traffic statistics, the NMS can obtain the traffic situation on
the network and thus performs effective network management.
Pre-configuration Tasks
Before configuring the statistics about the original traffic, complete the following tasks:
l
l
Data Preparation
To configure NetStream, you need the following data.
No.
1
2
3

7.3.2 Configuring the NetStream Function on an Interface

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ip netstream { inbound | outbound }
Issue 01 (2012-03-15)
Setting physical parameters on an interface
Setting the link-layer parameters of the interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
Data
Name and number of the interface on which
traffic statistics need to be collected
Version of the exported packets of the
NetStream traffic statistics
IP addresses and port numbers of the NSC
504