Huawei S9300 Configuration Manual page 193

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Cluster FTP NAT capability : enabled
There are 4 member(s) in the cluster, and 0 of them are down.
Step 10 Restart member switches in batches.
# Run the cluster-member reboot group-by member-number 2 to 3 command on the
administrator switch to restart Member-2 and Member-3.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-member reboot group-by member-number 2
to 3
Info: This command will take members reboot.Are you sure?[Y/N]y
Step 11 Verify the configuration.
Run the display member-reboot-stat command on administrator switch to check the restart
status of the member switches, and you can view that success is displayed, which indicates that
the specified member switches are restarted successfully.
[HUAWEI_2.Member-2] display member-reboot-stat
The result of member switchs rebooting:
------------------------------------------------------------------------
SN
------------------------------------------------------------------------
1
2
----End
Configuration Files
l
Issue 01 (2012-03-15)
Device
S9300
S9300
Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface GigabitEthernet1/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet1/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface GigabitEthernet1/0/3
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
ip-pool 10.0.0.1 255.0.0.0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MacAddress IPAddress
0003-0003-0003 10.0.0.3
0004-0004-0004 10.0.0.4
3 HGMP Configuration
Result
success
success
178