Configuring A Traffic Policy - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End

9.3.4 Configuring a Traffic Policy

Context
By configuring a traffic policy, the Switch classifies packets according to the DSCP value,
protocol type, IP address, port number, and fragmented packet type and redirects the packets to
be analyzed to the Eth-Trunk.
Do as follows on the Switch where a traffic policy needs to be configured and apply the traffic
policy on the GE interface of the Switch connected to the optical splitter.
Procedure
Step 1 Configure a traffic classifier. For details, see Configuring Complex Traffic Classification.
Step 2 Configure redirection.
1.
2.
3.
4.
Step 3 Configure a traffic policy. For details, see Configuring a Traffic Policy.
Step 4 Apply the traffic policy to the inbound interface where traffic distribution is configured.
1.
2.
3.
Issue 01 (2012-03-15)
NOTE
Currently, only the E-series boards and X12SA boardsE-series boards and EH1D2X12SSA0 boards support
the single-fiber communication function and this function needs to be configured with the license.
Run:
system-view
The system view is displayed.
Run:
traffic behavior behavior-name
A traffic behavior is created and the traffic behavior view is displayed.
Run:
redirect interface eth-Trunk trunk-id or redirect multi-trunk { eth-trunk
trunk-id } &<1-4>
The packets matching the traffic classifier are redirected to single or multiple Eth-Trunks.
Run:
quit
Return to the system view.
Run:
system-view
The system view is displayed.
Run:
interface gigabitethernet interface-number
The GE interface view is displayed.
Run:
traffic-policy policy-name inbound
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Traffic Distribution Configuration
559