Configuring The Snmp Query Test; Establishing The Configuration Task; Configuring The Snmp Query Test Parameters - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.11 Configuring the SNMP Query Test

This section describes how to configure a Simple Network Management Protocol (SNMP) query
test to check the communications between the host and SNMP agent.

6.11.1 Establishing the Configuration Task

Before configuring an SNMP query test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l
l
Data Preparation
To configure the SNMP query test, you need the following data.
No.
1
2
3
4

6.11.2 Configuring the SNMP Query Test Parameters

This part describes how to set SNMP query test parameters.
Issue 01 (2012-03-15)
System busy operation number:0
Operation sequence errors number:0
Drop operation number:0
Last good path Time:2010-06-21 15:41:01.7
1 . Hop 1
Send operation times: 3
Min/Max/Average Completion Time: 1/2/1
Sum/Square-Sum Completion Time: 4/6
RTD OverThresholds number: 0
Last Good Probe Time: 2010-06-21 15:41:01.7
Destination ip address:10.112.58.3
Lost packet ratio: 0 %
Configuring the SNMP agent
Configuring routes between the NQA client and the SNMP agent
Data
Administrator name and test name
IP address of the SNMP agent
(Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Connection fail number:0
RTT Stats errors number:0
Receive response times: 3
6 NQA Configuration
281