Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP Trace
test:
l To configure a protocol used by the LSP ping test, run the lsp-version { rfc4379 | draft6 }
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure after how many hops a test is considered failed, run the tracert-hopfailtimes
l To configure the initial and the maximum TTL values of the packet, run the tracert-
Step 7 Run:
start
The NQA test is started.
The start command has several forms. You can choose one of the following forms as required:
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain period of delay, run the start delay { seconds
----End

6.18.5 Checking the Configuration

After configuring the LSP traceroute test, you can view the test result.
Prerequisites
The configurations of the LSP Traceroute Test function are complete.
Context
Issue 01 (2012-03-15)
command.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Ping test, if the lsp-replymode no-reply command is configured, the test
result displays that the test fails regardless of whether the test, actually, succeeds or fails. If the test
succeeds, the test result shows the number of timeout packets. If the test fails, the test result shows the
number of discarded packets.
times command.
livetime first-ttl first-ttl max-ttl max-ttl command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
second | hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second |
hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ] command.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
315