Example For Checking The Multicast Path From The Source To Destination Host Through The Mtrace Test - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

6.35.20 Example for Checking the Multicast Path from the Source to

Destination Host Through the MTrace Test

Networking Requirements

all Switches to make Switches work synchronously, Receiver is added to the multicast group

225.1.1.1 and receives multicast data from Source normally. This test is performed to check how

the multicast traffic is transmitted to Receiver from Source.

You can configure an NQA MTrace test on Switch C to implement the MTrace function. You

can check the multicast path from the multicast source to the destination host.

Figure 6-22 Networking diagram for checking the multicast path from the multicast source to

the local Switch

Configuration Roadmap

The configuration roadmap is as follows:

Issue 01 (2012-03-15)

6-22, on the PIM-SM multicast network, implement the NTP protocal on

Configure Switch C as the NQA client and create an MTrace test on it.

Perform the test and view the test result.

Huawei Proprietary and Confidential

6 NQA Configuration