Starting The Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The maximum hops traced in hop-by-hop mode is set. first-ttl must be set to 1.
Step 5 Run:
mtrace-last-hop-address ipv4 ip-address
The IP address of the last-hop switch is specified.
Step 6 Run:
source-address ipv4 ip-address
The source IP address of the IGMP Tracert-Request packet is configured. The address must be
the address of the local interface. When the query type is set to multicast-tree, this step is not
required.
Step 7 Run:
mtrace-response-address ipv4 ip-address [ ttl value ]
The destination IP address and TTL of the IGMP Tracert-Response packet are set.
Step 8 Run:
timeout time
The timeout period for waiting for the IGMP Tracert-Response packet is set.
Step 9 Run:
probe-count number
The maximum number of times for the querier to initiate MTrace operations in the timeout
situations is set. The querier re-initiates an MTrace operation if receiving no IGMP Tracert-
Response packet within the timeout period.
Step 10 Run:
quit
Exit from the test instance view.
----End

6.23.5 Starting the NQA MTrace Test

This part describes how to start the MTrace test instance to perform the MTrace test for the
multicast path from the multicast source to the destination host.
Context
Do as follows on the switch that functions as the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
Issue 01 (2012-03-15)
NOTE
The start mode of the MTrace test is the same as that of other NQA tests. Here, take one mode as an example.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
339