Optional) Configuring Ldp Transport Addresses - Huawei Quidway S9300 series Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - MPLS
l
----End

2.3.6 (Optional) Configuring LDP Transport Addresses

LSRs need to confirm the transport address of the neighbor before an LDP session is set up
between LSRs. By default, a transport address of an LSR is the LSR ID.
Context
LDP sessions are created on the basis of TCP connections. Before two LSRs set up an LDP
session, they need to confirm the LDP transport address of each other, and then set up a TCP
connection.
Generally, you are not recommended to modify LDP transport addresses.
To modify LDP transport addresses, do as follows on the two LSRs at both ends of an LDP
session:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The view of the VLANIF interface on which the LDP session is set up is displayed.
Step 3 Run:
mpls ldp transport-address { interface-type interface-number | interface }
Issue 04 (2011-12-26)
Configuring a remote MPLS LDP session
Do as follows on the LSRs on both ends of a remote LDP session. The remote LDP session
is set up between two indirectly-connected LSRs or directly-connected LSRs.
1. Run:
system-view
The system view is displayed.
2. Run:
mpls ldp remote-peer remote-peer-name
The remote peer is created and the remote peer view is displayed.
3. Run:
remote-ip ip-address
The IP address of the remote MPLS LDP peer is configured.
The LSR ID configured in
address of the remote MPLS LDP peer.
NOTE
Modifying or deleting the configured address of a remote peer leads to the deletion of the related
remote LDP session.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuring an LSR ID
2 MPLS LDP Configuration
is recommended to be the IP
42