Optional) Adjusting The Performance Of The Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
If the mtrace command is run on a specified multicast VPN network, mtrace-query-type all-
router cannot be configured.
Step 8 (Optional) Run:
mtrace-last-hop-address ipv4 ip-address
The IP address of the last-hop switch is specified.
Step 9 (Optional) Run:
source-address ipv4 ip-address
The source address of the IGMP-Tracert-Query packet, which must be the address of the local
interface, is configured. If multicast-tree is applied, this step is skipped.
Step 10 Run:
quit
Exit from the NQA test instance view.
----End
6.23.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
ttl number
The TTL value, that is, the maximum hops traced in max-hop mode is set for the IGMP Tracert-
Request packet.
Step 4 Run:
tracert-livetime first-ttl first-ttl max-ttl max-ttl
Issue 01 (2012-03-15)
CAUTION
NOTE
The steps described in this procedure are all optional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
338