Huawei S9300 Configuration Manual page 319

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Context
Procedure
l
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
Run the display nqa results command to view the test results on the NQA client.
<Quidway> display nqa results test-instance admin lspping
NQA entry(admin, test) :testflag is inactive ,testtype is lspping
1 . Test 1 result
Issue 01 (2012-03-15)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
[ test-instance admin-name test-name ] command to view test results. By the default, the command output
contains the records about only the last five tests.
Run the display nqa results command to view the test results on the NQA client.
Statistics about errors
– Number of unroutable connections
– Number of wrong sequence numbers
– Timeout times of the test packets
History statistics of each test packet
– Timestamp added when each test packet is sent
– Timestamp added when each test packet is received
– Packets status displayed on the NQA client
Statistics of results of each test
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum(high 32 bit and low 32 bit)
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:100.1.1.200
Min/Max/Average Completion Time: 4/5/4
Sum/Square-Sum Completion Time: 13/57
Last Good Probe Time: 2007-11-19 19:46:28.8
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
304