Huawei S9300 Configuration Manual page 497
Hide thumbs
Also See for S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (567 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Configure routes among PE and CE.
Step 2 Configure the Martini VPLS on the MPLS backbone network.
For configuration details, refer to the chapter "VPLS Configuration" in the Configuration Guide
- VPN.
Step 3 Configure Ethernet CFM on PEs.
# Configure PE1.
[PE1] cfm enable
[PE1] cfm md md1
[PE1-md-md1] ma ma1
[PE1-md-md1-ma-ma1] ccm-interval 10000
[PE1-md-md1-ma-ma1] map vsi ldp1
[PE1-md-md1-ma-ma1] mep mep-id 1 interface gigabitethernet 1/0/0.1 inward
[PE1-md-md1-ma-ma1] remote-mep mep-id 2
[PE1-md-md1-ma-ma1] remote-mep mep-id 3
[PE1-md-md1-ma-ma1] quit
# Configure PE2.
[PE2] cfm enable
[PE2] cfm md md1
[PE2-md-md1] ma ma1
[PE2-md-md1-ma-ma1] ccm-interval 10000
[PE2-md-md1-ma-ma1] map vsi ldp1
[PE2-md-md1-ma-ma1] mep mep-id 2 interface gigabitethernet 1/0/0.1 inward
[PE2-md-md1-ma-ma1] remote-mep mep-id 1
[PE2-md-md1-ma-ma1] remote-mep mep-id 3
[PE2-md-md1-ma-ma1] quit
# Configure PE3.
[PE3] cfm enable
[PE3] cfm md md1
[PE3-md-md1] ma ma1
[PE3-md-md1-ma-ma1] ccm-interval 10000
[PE3-md-md1-ma-ma1] map vsi ldp1
[PE3-md-md1-ma-ma1] mep mep-id 3 interface gigabitethernet 1/0/0.1 inward
[PE3-md-md1-ma-ma1] remote-mep mep-id 1
[PE3-md-md1-ma-ma1] remote-mep mep-id 2
[PE3-md-md1-ma-ma1] quit
Step 4 Configure a VPLS MAC ping test instance.
1.
Step 5 Verify the configuration.
Enter the MAC ping instance view on PE1 and then run the display nqa results command. You
can see that the test result is "success".
Issue 01 (2012-03-15)
Configure a VPLS MAC Ping test instance and start the test instance.
# Configure PE1.
<PE1> system-view
[PE1] nqa test-instance test macping
[PE1-nqa-test-macping] test-type macping
[PE1-nqa-test-macping ] destination-address mac 00e0-fca4-8ae7
[PE1-nqa-test-macping ] md md1 ma ma1
[PE1-nqa-test-macping] mep mep-id 1
# Start the test instance.
[PE1-nqa-test-macping ] start now
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
482
Advertisement
Table of Contents
