Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.17.4 Checking the Configuration

After configuring the LSP jitter test, you can view the test result.
Prerequisites
The configurations of the LSP Test function are complete.
Context
Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
For the LSP Jitter test, run the display nqa results command. If the test is successful, the
following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, lspjitter) :testflag is inactive ,testtype is lspjitter
1 . Test 1 result
SendProbe:60
Completion:success
Min/Max/Avg/Sum RTT:1/24/3/156
NumOfRTT:60
Operation sequence errors number:0
System busy operation number:0
Issue 01 (2012-03-15)
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Statistics about errors
– Number of unroutable connections
– Number of wrong sequence numbers
– Timeout times of the test packets
History statistics of each test packet
– Timestamp added when each test packet is sent
– Timestamp added when each test packet is received
– Packets status displayed on the NQA client
Statistics of results of each test
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
The test is finished
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:60
RTD OverThresholds number:0
RTT Square Sum:928
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
6 NQA Configuration
309