Huawei S9300 Configuration Manual page 465

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Configure a dynamic multi-hop PW.
Configure a dynamic multi-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the S9300&S9300E
Terabit Routing Switch Configuration Guide - VPN.
Step 2 Configure a PWE3 Ping test on a multi-hop PW.
# Configure U-PE1.
<U-PE1> system-view
[U-PE1] nqa test-instance test pwe3ping
[U-PE1-nqa-test-pwe3ping] test-type pwe3ping
[U-PE1-nqa-test-pwe3ping] local-pw-id 100
[U-PE1-nqa-test-pwe3ping] local-pw-type ppp
[U-PE1-nqa-test-pwe3ping] label-type control-word
[U-PE1-nqa-test-pwe3ping] remote-pw-id 200
Step 3 Perform the test.
[U-PE1-nqa-test-pwe3ping] start now
Step 4 Verify the test result.
After running the display nqa results command on the PE device, you can see that the test is
successful.
[U-PE1-nqa-test-pwe3ping] display nqa results
NQA entry(test, pwe3ping) :testFlag is inactive ,testtype is pwe3ping
1 . Test 1 result
----End
Configuration Files
l
Issue 01 (2012-03-15)
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Min Positive Jitter: 0
Max Positive Jitter: 0
Positive Jitter Num: 0
Positive Jitter Sum: 0
Positive Jitter Square Sum: 0
Packet Loss: 0
Destination ip address:40.1.1.2
Min/Max/Average Completion Time: 60/110/86
Sum/Square-Sum Completion Time: 260/23800
Average Single-Way Completion Time: 30
Last Good Probe Time: 2008-9-29 14:38:48.2
Configuration file of CE-A
#
sysname CE-A
#
vlan batch 110
#
interface Vlanif110
ip address 100.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
Min Negative Jitter: 0
Max Negative Jitter: 0
Negative Jitter Num: 0
Negative Jitter Sum: 0
Negative Jitter Square Sum: 0
Packet Loss Ratio: 0
6 NQA Configuration
450