Huawei S9300 Configuration Manual page 145

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Context
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface gigabitethernet 1/0/1
[Administrator-1-GigabitEthernet1/0/1] port link-type trunk
[Administrator-1-GigabitEthernet1/0/1] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/1] quit
[Administrator-1] interface gigabitethernet 1/0/2
[Administrator-1-GigabitEthernet1/0/2] port link-type trunk
[Administrator-1-GigabitEthernet1/0/2] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/2] quit
[Administrator-1] interface gigabitethernet 1/0/3
[Administrator-1-GigabitEthernet1/0/3] port link-type trunk
[Administrator-1-GigabitEthernet1/0/3] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet1/0/3] quit
Issue 01 (2012-03-15)
Create a cluster and configure basic HGMP functions for the cluster according to the steps
described in the section
Cluster.
Disable FTP NAT on the administrator switch (The function is disabled by default.)
NOTE
Related configurations of cluster NAT must be performed on the administrator switch.
Configure routes on the administrator switch and member switches to ensure that reachable
routes exist between the FTP server and member switches.
For the situation that Member-3 accesses the FTP server (2.0.0.1/8) out of the cluster:
l Run the ftp command on the member switch to set up a connection with the public FTP
server of the cluster.
For the situation that the device out of the cluster accesses the FTP server (Member-2):
l Run the FTP client program on the PC and create an FTP connection with the member
switch.
Management VLAN ID of the cluster, that is 10
IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the FTP server
Address pool of the cluster, that is 10.0.0.0/8
IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
Member ID serving as the FTP server in the cluster with the member ID being 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example for Configuring Basic HGMP Functions for a
3 HGMP Configuration
130