Huawei S9300 Configuration Manual page 361

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type pwe3ping
The test type is set to PWE3 Ping.
Step 4 (Optional) Run:
vc-type ldp
The method of setting up a PW is configured.
Step 5 (Optional) Run:
local-pw-type { local-pw-type | ip-interworking }
The type of the local PW is configured. By default, the type is Ethernet.
Step 6 Run:
lsp-version { rfc4379 | draft6 | ptn-mode }
A protocol is configured for the LSP test instance.
Step 7 (Optional) Run:
label-type { control-word | { { label-alert | normal } [ no-control-word ] } }
The type of the PW label is configured.
Step 8 Run:
local-pw-id local-pw-id
The ID of the local end of the PW is configured.
Step 9 (Optional) Run the following commands to configure other parameters for the PWE3 Ping test.
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
Issue 01 (2012-03-15)
NOTE
l If the label-type is control-word:
1. Run:
destination-address ipv4 ip-address { lsp-masklen mask-length | lsp-
loopback loopback-address }*
The destination IP address is configured for the PWE3 ping test.
2. Run:
remote-pw-id remote-pw-id
The remote PW ID is configured.
l If the label-type is label-alert, the destination IP address for the PWE3 ping testis configured using the
destination-address ipv4 ip-address { lsp-masklen mask-length | lsp-loopback loopback-address }
* command.
l If the label-type is normal:
1. Run:
destination-address ipv4 ip-address { lsp-masklen mask-length | lsp-
loopback loopback-address }*
The destination IP address is configured for the PWE3 ping test.
2. Run:
remote-pw-id remote-pw-id
The remote PW ID is configured.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
346