Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Step 6 Run:
lsp-version { rfc4379 | draft6 | ptn-mode }
A protocol is configured for the LSP test instance.
Step 7 (Optional) Run:
label-type { control-word | label-alert | normal }
The type of the PW label is configured.
Step 8 Run:
local-pw-id local-pw-id
The ID of the local end of the PW is configured.
Step 9 (Optional) Run the following commands to configure other parameters for the PWE3 Trace test:
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure maximum hops of the PWE3 Trace test, run the tracert-hopfailtimes
l To configure the initial TTL value and maximum TTL value of the packet, run the tracert-
Step 10 Run:
start
The NQA test is started.
Select the start mode as required because the startcommand has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.26.3 Checking the Configuration

After performing the PWE3 trace test for a single-hop PW, you can view the test result.
Prerequisites
The configurations of the PWE3 Trace Test function are complete.
Issue 01 (2012-03-15)
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
timescommand.
livetime first-ttl first-ttl max-ttl max-ttl command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
350