Establishing The Configuration Task; Configuring The Tcp Server - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.12.1 Establishing the Configuration Task

Before configuring a TCP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
To obtain the time for the specified port to respond to a TCP connection request, you can create
an NQA TCP test instance.
Pre-configuration Tasks
Before configuring the TCP test, configure reachable routes between the NQA client and the
TCP server.
Data Preparation
To configure the TCP test, you need the following data.
No.
1
2
3
4

6.12.2 Configuring the TCP Server

The IP address and number of the port monitored by the server must be identical with those
configured on the client.
Context
Do as follows on the NQA server (TCP server):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-server tcpconnect [ vpn-instance vpn-instance-name ] ip-address port-number
The TCP monitoring service is configured.
Issue 01 (2012-03-15)
Data
Administrator name and test name
IP address and port number monitored by the TCP server
(Optional) Destination port numbers of the probe packets sent by the TCP client and
source IP addresses , source port numbers of test packets, interval for sending test
packets, and percentage of the failed NQA tests
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
284