Configuring Ntp Authentication In Unicast Client/Server Mode; Configuring Ntp Authentication In Peer Mode - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End
4.4.4 Configuring NTP Authentication in Unicast Client/Server
Mode
By configuring the authentication key ID used in the synchronization with the specific NTP
server on the NTP client, you can apply NTP authentication in Client/Server mode.
Context
Do as follows on the switch that functions as an NTP unicast client.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ntp-service unicast-server ip-address [ authentication-keyid key-id | version
number | source-interface interface-type interface-number | vpn-instance vpn-
instance-name
The ID of the authentication key used for the synchronization of the server and client clocks is
configured.
----End

4.4.5 Configuring NTP Authentication in Peer Mode

By configuring the authentication key ID used in the synchronization with the peer on the local
end, you can apply NTP authentication in peer mode.
Context
Do as follows on the switch that functions as the symmetric active end.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2012-03-15)
NTP authentication is enabled.
3. Run:
ntp-service authentication-keyid key-id authentication-mode md5 password
The NTP authentication key is configured.
4. Run:
ntp-service reliable authentication-keyid key-id
The authentication key is declared to be reliable.
| preference ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
4 NTP Configuration
229