Debugging Netstream; Example For Configuring Netstream; Example For Configuring Ipv4 Traffic Statistics - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

7.8.1 Debugging NetStream

For more information about the debugging command, refer to the Debugging Reference.

Step 1 Run the debugging ip netstream ip { event | packet } command in the user view to enable the

debugging of IP NetStream.

This section provides several configuration examples of NetStream.

Networking Requirements

through Switch A. The NetStream function is enabled on Switch B. The carrier collects traffic

statistics on the packets sent and received by GE1/0/0 of Switch B. The traffic statistics serve

as the basis for network accounting.

Figure 7-2 Networking diagram for configuring NetStream

Configuration Roadmap

The configuration roadmap is as follows:

Issue 01 (2012-03-15)

Debugging affects the performance of the system. So, after debugging, run the undo debugging all

command to disable it immediately.

7-2, the enterprise network is connected to the access Switch B of the carrier

Set IP addresses for interfaces on Switch A and Switch B.

Huawei Proprietary and Confidential

7 NetStream Configuration