Checking The Configuration; Configuring The Dns Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End

6.8.3 Checking the Configuration

After configuring the HTTP test, you can view the test result.
Prerequisites
The configurations of the HTTP Test function are complete.
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, http) :testflag is inactive ,testtype is http
1 . Test 1 result

6.9 Configuring the DNS Test

This section describes how to configure a Domain Name System (DNS) test to check the DNS
resolution speed.
Issue 01 (2012-03-15)
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
DNSRTT: indicates the time when the DNS sends a query request.
TCPConnectRTT: indicates the time when the TCP connection is established.
TransactionRTT and RTT: indicates the durations of data transmission and HTTP test
respectively.
The test is finished
SendProbe:3
Completion:success
MessageBodyOctetsSum: 411
DNSQueryError number: 0
TcpConnError number : 0
DNSRTT Sum/Min/Max:0/0/0
TransactionRTT Sum/Min/Max: 3/1/1
RTT Sum/Min/Max/Avg: 7/1/5/2
DNSServerTimeout:0 TCPConnectTimeout:0
Lost packet ratio:0%
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:3
RTD OverThresholdsnumber: 0
TargetAddress: 100.2.1.200
HTTPError number: 0
System busy operation number:0
TCPConnectRTT Sum/Min/Max: 6/1/4
TransactionTimeout: 0
6 NQA Configuration
275