Configuring The Nqa Mtrace Test; Optional) Adjusting The Performance Of The Nqa Mtrace Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The test type is set to MTrace.
Step 4 Run:
quit
Exit from the test instance view.
----End

6.20.3 Configuring the NQA MTrace Test

This part describes how to set parameters for the MTrace test for the RPF path from the multicast
source to the querier.
Context
Do as follows on the switch with the NQA MTrace test instance being created:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
mtrace-source-address ipv4 ip-address
The address of the multicast source is specified.
Step 4 (Optional)The VPN instance is specified.
vpn-instance vpn-instance-name
Step 5 Run:
quit
Exit from the test instance view.
----End
6.20.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
Issue 01 (2012-03-15)
NOTE
The steps described in this procedure are all optional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
322