Enabling Flexible Netstream On Interfaces; Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
To enable the interface to collect statistics about inbound and outbound IPv6 unicast traffic, run
the ipv6 netstream { inbound | outbound } command.
By default, the NetStream function is disabled in inbound and outbound directions. In this case,
statistics about IPv4 and IPv6 unicast traffic cannot be collected.
The Netstream can collect statistics about inbound and outbound packets separately.
Step 4 (Optional) Run:
ip netstream sampler fix-packets packet-interval { inbound | outbound }
The IPv4 fixed-packets sampling ratio on an interface is set.
By default, the fixed-packets sampling ratio on an interface is 1000:1.
Step 5 (Optional) Run:
ipv6 netstream sampler fix-packets packet-interval { inbound | outbound }
The IPv6 fixed-packets sampling ratio on an interface is set.
By default, the fixed-packets sampling ratio on an interface is 1000:1.
----End

7.6.6 Enabling Flexible NetStream on Interfaces

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port ip netstream record record-name
The record is applied to the interface.
----End

7.6.7 Checking the Configuration

Prerequisites
All configurations are complete.
Issue 01 (2012-03-15)
NOTE
Only one record can be configured on an interface. To modify the record in the same interface view, you
must first delete the existing configuration by running the undo port ip netstream record command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 NetStream Configuration
517