Example For Configuring The Pwe3 Ping Test On A Single-Hop Pw - Huawei S9300 Configuration Manual

Hide thumbs Also See for S9300:

Table of Contents

S9300&S9300E Terabit Routing Switch

Configuration Guide - Network Management

6.35.21 Example for Configuring the PWE3 Ping Test on a Single-

Networking Requirements

A and PE-B are connected through the MPLS backbone network. A dynamic PW needs to be

set up between PE-A and PE-B through the LSP tunnel.

The PWE3 Ping function of the single-hop PW needs to be performed to test the connectivity

of the PW between PE-A and PE-B.

Figure 6-23 Networking diagram for configuring the PWE3 Ping test on the single-hop PW

Configuration Roadmap

The configuration roadmap is as follows:

Issue 01 (2012-03-15)

area 0.0.0.0

network 11.1.0.0 0.0.0.255

network 11.1.1.0 0.0.0.255

network 11.1.2.0 0.0.0.255

6-23, CE-A and CE-B are connected to PE-A and PE-B respectively. PE-

192.2.2.2/32

100.1.1.1/24

Run the IGP protocol on the backbone network to make the routes between Switches on

the backbone network reachable.

Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.

Set up the MPLS LDP peer relation between the two PE devices on the two ends of the

Create an MPLS L2VC connection between the two PE devices.

Huawei Proprietary and Confidential

MPLS Backbone

192.4.4.4/32

6 NQA Configuration

192.3.3.3/32

100.1.1.2/24