Huawei S9300 Configuration Manual page 151

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
# Configure member switch 1.
[HUAWEI_1.Member-1] ip route-static 2.0.0.0 8 10.0.0.1
# Configure member switch 2.
[HUAWEI_2.Member-2] ip route-static 2.0.0.0 8 10.0.0.1
# Configure member switch 3.
[HUAWEI_3.Member-3] ip route-static 2.0.0.0 8 10.0.0.1
Step 10 Verify the configuration.
l Member switches access the FTP server in non-NAT mode.
l Devices out of the cluster access the FTP server in the cluster in non-NAT mode.
----End
Configuration Files
l
Issue 01 (2012-03-15)
NOTE
Multiple member switches can be configured simultaneously through incremental configuration. For
configuration details, see
HGMP Cluster.
< HUAWEI_3.Member-3> ftp 2.0.0.1
Trying 2.0.0.1 ...
Press CTRL+K to abort
Connected to 2.0.0.1.
220 FTP service ready.
User(2.0.0.1:(none)):hgmp
331 Password required for hgmp.
Enter password:
230 User logged in.
[ftp]
# Configure an FTP server on the corresponding member switch (Member-2). The
configuration details see Configuration Files, and are not mentioned here.
# Run the FTP client program on the PC and set up an FTP connection with Member-2 in
non-NAT mode.
NOTE
Devices out of the cluster access the FTP server in the cluster in non-NAT mode. The IP address of
the FTP server is that of the management VLANIF interface on the member switch. The FTP server
uses a port number reserved in the cluster instead of the commonly-used 21.
ftp> open 10.0.0.2
Connected to 10.0.0.2
220 FTP service ready.
User (10.0.0.2:(none)): hgmp
331 Password required for hgmp.
Password:
230 User logged in.
ftp>
Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Example for Configuring the Incremental Configuration Function for an
3 HGMP Configuration
136