Example For Configuring Mac Ping To Detect The Connectivity Of A Vlan Network - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.29 Example for Configuring MAC Ping to Detect the
Connectivity of a VLAN network
Networking Requirements
As shown in
CFM functions. A MAC ping test instance can be used to detect the connectivity and locate fault
of the VLAN network.
Figure 6-31 Networking diagram of configuring MAC ping for detecting the connectivity of a
VLAN network
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the IP address. (The detailed procedure is not mentioned here.)
Issue 01 (2012-03-15)
vlan batch 10
#
interface Vlanif10
ip address 11.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
return
Figure 6-31, all devices are on a VLAN network and are enabled with basic Ethernet
VLAN10
Configure a VLAN network and the service environment for starting the NQA test instance.
Configure Ethernet CFM and establish the mapping relationship between CFM and VLAN.
Configure an NQA MAC ping test instance on Switch A, and specify mandatory
configurations for the test instance.
Start the NQA MAC ping test instance.
VLAN ID
MAC address of the remote device
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLAN VLAN10
6 NQA Configuration
SwitchB
477