Huawei S9300 Configuration Manual page 502

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Networking Requirements
As shown in
multicast services.
The receiver is added to the multicast group whose IP address is 225.1.1.1 to receive multicast
data sent from the source. Switch A is the last hop.
The mtrace command is run on Switch B to check the RPF path from the multicast source to
the destination host on a specified multicast VPN network. The command output shows
information about nodes on the RPF path, which provides references for the faulty node
detection.
Figure 6-33 Networking diagram of a single-AS MD VPN
Source:10.0.40.90/24
SwitchE
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Issue 01 (2012-03-15)
Figure 6-33, MD is used on a single-AS MPLS/BGP VPN network to deploy
VLANIF60
10.0.4.10/24
LoopBack0：
VLANIF50
20.0.5.50/24
VLANIF40
Configure BGP/MPLS IP VPN to ensure that the VPN network works normally and unicast
routes are reachable.
Enable multicast and Protocol Independent Multicast (PIM) globally. Packet transmission
between PEs and P is multicast implementation on the public network while packet
transmission between the PE and the CE is multicast implementation in VPN instances.
Configure identical share-group address, MTI, and switch-address-pool range of Switch-
MDT for the same VPN instance on each PE.
Configure the MTI address of each PE as the IBGP peer interface address on the public
network, and enable PIM on the MTI.
Configure Switch B as an NQA client and create a Mtrace test instance on it.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
LoopBack0：
4.4.4.4
10.0.4.50/24
10.0.1.30/24
SwitchD SwitchB
20.0.5.40/24
SwitchC
VLANIF20
Destination:10.0.2.10/24
10.0.1.10/24
VLANIF10
2.2.2.2
20.0.1.30/24
VLANIF30
20.0.1.20/24
6 NQA Configuration
SwitchA
487