Example For Configuring The Tcp Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l

6.35.8 Example for Configuring the TCP Test

Networking Requirements
As shown in
TCP connection between Switch A and Switch B.
Figure 6-10 Networking diagram for configuring the TCP test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Issue 01 (2012-03-15)
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
snmp-agent
snmp-agent local-engineid 000007DB7F00000100006294
#
return
Figure 6-10, the NQA TCP Private test is used to obtain the time for setting up a
GE1/0/0 GE1/0/0
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the monitoring port number on the NQA server and create an NQA TCP test on
the NQA client.
Host address of the server
Port number used to monitor the TCP service on the server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE2/0/0
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE1/0/0
NQA Server
397