Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Step 6 (Optional) Perform the following as required to configure other parameters for the LSP Ping
test:
l To configure a protocol used by the LSP ping test, run the lsp-version { rfc4379 | draft6 }
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the packet size, run the datasize size command.
l To configure the maximum TTL value of the packet, run the ttl number command.
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure the padding character of the packet, run the datafill fillstring command.
l To configure the interval for sending test packets, run the interval seconds interval
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
Step 7 Run:
start
The NQA test is started.
The start command has several forms. You can choose one of the following forms as required:
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain period of delay, run the start delay { seconds
----End

6.16.5 Checking the Configuration

After configuring the LSP ping test, you can view the test result.
Prerequisites
The configurations of the LSP Ping Test function are complete.
Issue 01 (2012-03-15)
command.
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Ping test, if the lsp-replymode no-reply command is configured, the test
result displays that the test fails regardless of whether the test, actually, succeeds or fails. If the test
succeeds, the test result shows the number of timeout packets. If the test fails, the test result shows the
number of discarded packets.
NOTE
The sum of the data size and the size of the packet header must be less than the MTU of the interface;
otherwise, the test may fail.
command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
second | hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second |
hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ] command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
303