Example For Configuring The Lsp Trace Test For Checking The Cr-Lsp Hotstandby Tunnel - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
6.35.32 Example for Configuring the LSP Trace Test for Checking
the CR-LSP Hotstandby Tunnel
This part provides examples for configuring an LSP Trace test to detect faults on the CR-LSP
hot standby tunnels.
Networking Requirements
In the MPLS VPN as shown in
up on Switch A, and CR-LSP hot standby is configured on the TE tunnel.
Issue 01 (2012-03-15)
network 4.4.4.4 0.0.0.0
#
rip 2 vpn-instance red
network 10.0.0.0
network 20.0.0.0
import-route direct
import-route bgp cost 3
#
igmp
#
return
Configuration file of Switch E
#
sysname SwitchE
#
router id 5.5.5.5
#
multicast routing-enable
#
vlan batch 50 60
#
interface Vlanif60
ip address 10.0.40.80 255.255.255.0
pim sm
#
interface Vlanif50
ip address 10.0.4.10 255.255.255.0
pim sm
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 50
port hybrid untagged vlan 50
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 60
port hybrid untagged vlan 60
#
interface LoopBack1
ip address 5.5.5.5 255.255.255.255
pim sm
#
rip 2
network 10.0.0.0
import-route direct
import-route bgp
#
igmp
#
pim
c-bsr LoopBack1
c-rp LoopBack1
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 6-34, a TE tunnel with Switch C being the egress is set
6 NQA Configuration
494