Huawei S9300 Configuration Manual page 494

Table of Contents

Advertisement

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
# Configure Switch A.
<SwitchA> system-view
[SwitchA] nqa test-instance test macping
[SwitchA-nqa-test-macping ] test-type macping
[SwitchA-nqa-test-macping ] destination-address mac 00e0-fca4-8ae7
[SwitchA-nqa-test-macping ] md md1 ma ma1
[SwitchA-nqa-test-macping] mep mep-id 1
# Start the test instance.
[SwitchA-nqa-test-macping ] start now
Step 5 Verify the configuration.
Enter the MAC ping test instance view on Switch A and then run the display nqa results
command. You can see that the test result is "success".
[SwitchA ] display nqa results
NQA entry(test, macping) :testFlag is inactive ,testtype is macping
1 . Test 1 result
----End
Configuration Files
l
Issue 01 (2012-03-15)
The test is finished
SendProbe:3
Completion:success
OWD OverThresholds SD number:0
Min/Max/Avg/Sum RTT:1/1/1/1
NumOfRTT:3
Operation sequence errors number:0
System busy operation number:0
Min Positive SD:0
Max Positive SD:0
Positive SD Number:0
Positive SD Sum:0
Positive SD Square Sum :0
Min Negative SD:0
Max Negative SD:0
Negative SD Number:0
Negative SD Sum:0
Negative SD Square Sum :0
Min Delay SD:0
Avg Delay SD:0
Max Delay SD:0
Delay SD Square Sum:0
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:0
jitter out value:0.0000000
NumberOfOWD:0
OWD SD Sum:0
ICPIF value: 0
TimeStamp unit: ms
Packet Rewrite Ratio: 0%
Packet Disorder Ratio: 0%
Fragment-disorder Ratio: 0%
Configuration file of Switch A
#
sysname SwitchA
#
cfm enable
#
interface GigabitEthernet1/0/1
undo shutdown
portswitch
port default vlan 10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:3
RTD OverThresholds number:0
OWD OverThresholds DS number:0
RTT
Square Sum:3
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
Min Positive DS:0
Max Positive DS:0
Positive DS Number:0
Positive DS Sum:0
Positive DS Square Sum :0
Min Negative DS:0
Max Negative DS:0
Negative DS Number:0
Negative DS Sum:0
Negative DS Square Sum :0
Min Delay DS:0
Avg Delay DS:0
Max Delay DS:0
Delay DS Square Sum:0
Packet Loss DS:0
Average of Jitter:0
Average of Jitter DS:0
jitter in value:0.0000000
Packet Loss Ratio: 100%
OWD DS Sum:0
MOS-CQ value: 0
Packet Rewrite Number: 0
Packet Disorder Number: 0
Fragment-disorder Number: 0
6 NQA Configuration
479

Advertisement

Table of Contents
loading

This manual is also suitable for:

S9300e

Table of Contents