Establishing The Configuration Task; Configuring Parameters For The Pwe3 Ping Test On A Multi-Hop Pw - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.25.1 Establishing the Configuration Task

Before configuring a PWE3 ping test for a multi-hop PW, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data. This can help
you complete the configuration task quickly and accurately.
Applicable Environment
To check the connectivity of the multi-hop PW using LDP as the signaling protocol, you can
perform the PWE3 Ping test on the multi-hop PW.
Pre-configuration Tasks
Before configuring the PWE3 Ping test on a multi-hop PW, you must correctly configure the
dynamic multi-hop PW or the static multi-hop PW.
Data Preparation
To configure the PWE3 Ping test on a multi-hop PW, you need the following data.
No.
1
2
3
4
5
6
6.25.2 Configuring Parameters for the PWE3 Ping Test on a Multi-
Hop PW
This part describes how to set PWE3 ping test parameters for a multi-hop PW.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
Issue 01 (2012-03-15)
Data
ID of the local end of the PW
ID or IP address of the remote end of the PW
Type of the PW
(Optional) Response mode of the Echo packets, LSP EXP, maximum hops, number
of probes, TTL value, and timeout period of the packets
Type and number of the interface connected with the CE
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
345