Checking The Configuration - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the nqa test-instance admin-name test-name command, enter the NQA test instance view.
Step 3 Run:
test-type { dhcp | dns | ftp | http | icmp | jitter | lspjitter | lspping |
lsptrace | snmp | tcp | trace | udp | pathmtu | pwe3trace | pwe3ping | macping |
mactnlping | icmpjitter | pathjitter | mping | mtrace | vplsping | vplstrace |
vplsmping | vplsmtrace}{ dhcp | dns | ftp | http | icmp | jitter | lspjitter |
lspping | lsptrace | snmp | tcp | trace | udp | pathmtu | pwe3trace | pwe3ping |
macping | mactrace | icmpjitter | pathjitter | mping | mtrace | vplsping |
vplstrace | vplsmping | vplsmtrace | vplspwping | vplspwtrace | gmacping |
gmactrace }
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.32.8 Checking the Configuration

After configuring the system to send test results to the FTP server, you can view the
configuration.
Issue 01 (2012-03-15)
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm | dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
376