Starting The Nqa Mtrace Test; Setting Policies For Filtering Queriers - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The timeout period for waiting for the IGMP Tracert-Response packet is set.
Step 10 Run:
probe-count number
The maximum number of times for the querier to initiate MTrace operations in the timeout
situations is set. The querier re-initiates an MTrace operation if receiving no IGMP Tracert-
Response packet within the timeout period.
Step 11 Run:
quit
Exit from the test instance view.
----End

6.22.5 Starting the NQA MTrace Test

This part describes how to start the MTrace test instance to perform the MTrace test for the RPF
path from the multicast source to the destination host.
Context
Do as follows on the switch that functions as the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
start now
The NQA MTrace test is started.
Step 4 Run:
quit
Exit from the test instance view.
----End

6.22.6 Setting Policies for Filtering Queriers

You can set policies to filter queriers only on the last-hop that receives the unicast IGMP Tracert
Query packet.
Issue 01 (2012-03-15)
NOTE
The start mode of the MTrace test is the same as that of other NQA tests. Here, take one mode as an example.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
333