Huawei S9300 Configuration Manual page 51

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Figure 1-5 Networking diagram for configuring a device to communicate with an NM station
by using SNMPv2c
1.1.1.1/24
1.1.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
l
l
Procedure
Step 1 Configure available routes between the switch and the NM stations. Details for the configuration
procedure are not provided here.
Step 2 Enable the SNMP agent.
Issue 01 (2012-03-15)
NMS1
IP Network
NMS2
Enable the SNMP agent.
Configure the switch to run SNMPv2c.
Configure an ACL to allow NMS2 to manage every MIB object except HGMP on the
switch.
Configure the switch to send informs to NMS2 to ensure alarm sending reliability.
Configure the equipment administrator's contact information on the switch.
Configure NMS2.
SNMP version
Community name
ACL number
IP address of the NM station
Inform alarm timeout interval
Number of retransmission attempts for an Inform alarm
Maximum number of pending Inform alarms
Aging time of trap logs
Equipment administrator's contact information
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
VLANIF100
1.1.2.1/24
Switch
1 SNMP Configuration
36