Example For Configuring A Device To Communicate With An Nm Station By Using Snmpv2C - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
#
acl number 2001
rule 5 permit source 1.1.1.2 0
rule 6 deny source 1.1.1.1 0
#
interface Vlanif100
ip address 1.1.2.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface LoopBack0
ip address 1.1.3.1 255.255.255.255
#
ospf 1
area 0.0.0.0
network 1.1.2.0 0.0.0.255
network 1.1.3.1 0.0.0.0
#
snmp-agent
snmp-agent local-engineid 000007DB7FFFFFFF00001AA7
snmp-agent community write adminnms2 mib-view allexthgmp acl 2001
snmp-agent sys-info contact call Operator at 010-12345678
snmp-agent sys-info version v1
snmp-agent target-host trap address udp-domain 1.1.1.2 params securityname
1.1.3.1
snmp-agent mib-view included allexthgmp iso
snmp-agent mib-view excluded allexthgmp hwCluster
snmp-agent trap source LoopBack0
snmp-agent trap queue-size 200
snmp-agent trap life 60
snmp-agent trap enable
#
return
1.5.2 Example for Configuring a Device to Communicate with an
NM Station by Using SNMPv2c
This section provides an example to describe how to configure a device to communicate with
an NM station by using SNMPv2c and how to specify the MIB objects that can be managed by
the NM station.
Networking Requirements
As shown in
across a public network. According to the network planning, NMS2 can manage every MIB
object except HGMP on the switch, and NMS1 does not manage the switch.
On the switch, only the modules that are enabled by default are allowed to send alarms to NMS2.
This prevents an excess of unwanted alarms from being sent to NMS2. Excessive alarms can
make faults location difficult. Informs need to be used to ensure that alarms are received by
NMS2 because alarms sent by the switch have to travel across the public network to reach NMS2.
Equipment administrator's contact information needs to be configured on the switch. This allows
the NMS administrator to contact the equipment administrator quickly if a fault occurs.
Issue 01 (2012-03-15)
Figure 1-5, two NM stations (NMS1 and NMS2) and the switch are connected
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
v3
1 SNMP Configuration
35