Example For Configuring An Icmp Jitter Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management

6.35.16 Example for Configuring an ICMP Jitter Test

This part provides examples for configuring an ICMP jitter test to measure jitter on the network.
A server is not required in an ICMP jitter test and the peer device in the test instance can be non-
Huawei devices.
Networking Requirements
As shown in
Switch A serves as the NQA client to test the jitter of the network between Switch A and Switch
B.
Figure 6-18 Networking diagram of an ICMP jitter test
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure a reachable route between Switch A and Switch B.
The configuration details are not mentioned here.
Step 2 Configure an NQA test instance for Switch A.
# Enable the NQA client and configure the ICMP jitter test instance.
<RouterA> system-view
[RouterA] nqa test-instance admin icmpjitter
[RouterA-nqa-admin-icmpjitter] test-type icmpjitter
[RouterA-nqa-admin-icmpjitter] destination-address ipv4
Step 3 Start the test.
[RouterA-nqa-admin-icmpjitter] start now
Issue 01 (2012-03-15)
#
Return
Figure 6-18,
GE1/0/0
VLANIF10
10.1.1.1/24
Configure Switch A as the NQA client and create an ICMP jitter test instance on Switch
A.
Configure Switch B as the NQA server.
IP address of Switch B
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
VLANIF10
10.1.1.2/24
SwitchB
6 NQA Configuration
10.1.1.2
421