Example For Configuring The Pwe3 Ping Test On A Multi-Hop Pw - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
l
6.35.22 Example for Configuring the PWE3 Ping Test on a Multi-
Hop PW
Networking Requirements
As shown in
through PPP. U-PE1 and U-PE2 are connected through the MPLS backbone network. The LSP
needs to be used and S-PE is set as the switching node to set up a dynamic multi-hop PW between
U-PE1 and U-PE2.
The PWE3 Ping function of the multi-hop PW needs to be performed to test the connectivity of
the PW between U-PE1 and U-PE2.
Issue 01 (2012-03-15)
#
interface LoopBack0
ip address 192.3.3.3 255.255.255.255
#
ospf 1
area 0.0.0.0
network 192.3.3.3 0.0.0.0
network 10.2.2.0 0.0.0.255
#
return
Configuration file of CE-B
#
sysname CE-B
#
vlan batch 140
#
interface Vlanif140
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 140
port hybrid untagged vlan 140
#
return
Figure 6-24, CE-A and CE-B are connected to U-PE1 and U-PE2 respectively
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
448