Example For Configuring The Test Of Sending Nqa Threshold Traps To The Nms - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
6.35.25 Example for Configuring the Test of Sending NQA
Threshold Traps to the NMS
Networking Requirements
As shown in
messages is enabled when a Jitter test is configured. After the Jitter test is complete, Switch A
sends a trap message to the NMS when the interval for transmitting the test packet from
Switch A to Switch C or from Switch C to Switch A exceeds the configured unidirectional
transmission threshold, or when the RTT of the test packet exceeds the configured bidirectional
transmission threshold. Network administrators can view the cause of a trap in the trap message
received by the NMS.
Figure 6-27 Network diagram for configuring the NQA threshold
VLANIF110
20.1.1.1/24
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Issue 01 (2012-03-15)
Figure 6-27, the trap threshold are configured and the function of sending trap
GE2/0/0
GE1/0/0
GE1/0/0
VLANIF120 VLANIF120
10.1.1.1/24
10.1.1.2/24
NOTE
For the information about clock synchronization, see "NTP" in the S9300&S9300E Terabit Routing Switch
Feature Description - Network Management.
Configure a Jitter test.
Configure the NQA thresholds.
Enable the function of sending trap messages.
Configure the function of sending trap messages to the NMS.
IP address and port number of the server-side host.
Type of the monitored service and monitoring port number
RTD threshold and OWD threshold
IP address of the NMS
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
NM Station
20.1.1.2/24
GE1/0/0
SwitchB
VLANIF130
30.1.1.2/24
GE2/0/0
VLANIF130
30.1.1.1/24
6 NQA Configuration
SwitchC
NQA Server
465