Configuring The Udp Test; Establishing The Configuration Task - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
Run the display nqa-server command,the status of the NQA server is displayed.
<Quidway> display nqa-server
NQA Server Max: 5000
NQA Concurrent TCP Server : 1
nqa-server tcpconnect 10.112.58.3 2000 ACTIVE

6.13 Configuring the UDP Test

This section describes how to configure a User Datagram Protocol (UDP) test to check the
responding speed of a UDP port.

6.13.1 Establishing the Configuration Task

Before configuring a UDP test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
To obtain the time for the specified port to respond to a UDP connection request, you can create
a UDP test instance.
Pre-configuration Tasks
Before configuring the UDP test, configure reachable routes between the NQA client and the
UDP server.
Data Preparation
To configure the UDP test, you need the following data.
No.
1
2
3
4
5
Issue 01 (2012-03-15)
Send operation times: 3
Completion:success
Attempts number:0
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.2.1.2
Min/Max/Average Completion Time: 31/62/51
Sum/Square-Sum Completion Time: 155/8649
Last Good Probe Time: 2006-8-5 15:55:15.3
Lost packet ratio: 0 %
Data
Administrator name and test name
IP address and port of the UDP server
Destination IP address and the port of the probe packets sent by the UDP client
(Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
NQA Server Num: 1
NQA Concurrent UDP Server: 0
6 NQA Configuration
287