Example For Configuring Flexible Netstream - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
port hybrid untagged vlan 20
#
bgp 65003
router-id 4.4.4.4
peer 10.3.1.1 as-number 65001
#
ipv4-family unicast
undo synchronization
peer 10.3.1.1 enable
#
return

7.9.3 Example for Configuring Flexible NetStream

Networking Requirements
As shown in
Switch A. The Flexible NetStream feature is configured on GE 1/0/0 of Switch B. Then you can
aggregate traffic based on destination IP addresses and port numbers, collect statistics on the
inbound traffic and outbound traffic on an interface, and send the traffic statistics to the NSC.
Figure 7-4 Networking diagram for configuring Flexible NetStream
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
Issue 01 (2012-03-15)
Figure 7-4, the enterprise network is connected to Switch B of the carrier through
User
GE 1/0/0
Network
VLANIF 100
10.1.1.1/24
SwitchA
Set IP addresses for the interfaces on Switch A and Switch B.
Specify the version of the exported packets.
Configure the source address, destination address, and destination port number for
exporting packets.
Configure the Flexible NetStream feature on GE 1/0/0 of Switch B.
IP address of each interface
Version of the exported packets
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE 2/0/0
VLANIF 200
10.2.1.1/24
NSC&NDA
10.2.1.2/24
GE 1/0/0
VLANIF 100
10.1.1.2/24
SwitchB
7 NetStream Configuration
528