Checking The Configuration; Configuring The Ftp Download Test - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
----End

6.5.3 Checking the Configuration

After configuring the ICMP test, you can view the test result.
Prerequisites
The configurations of the ICMP Test function are complete.
Context
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to view the test
results on the NQA client.
----End
Example
Run the display nqa results command. If the following is displayed, it means that the test is
successful.
l
l
l
For the ICMP test, you can also view the minimum time, maximum time, and RTT(Round Trip
Time ).
<Quidway> display nqa results
NQA entry(admin, test) :testflag is inactive ,testtype is icmp
1 . Test 1 result

6.6 Configuring the FTP Download Test

This section describes how to configure a File Transfer Protocol (FTP) download test to check
the FTP download performance.
Issue 01 (2012-03-15)
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five test results.
testflag is inactive
The test is finished
Completion:success
The test is finished
Send operation times: 3
Completion:success
Attempts number:1
Disconnect operation number:0
System busy operation number:0
Operation sequence errors number:0
Destination ip address:10.112.58.3
Min/Max/Average Completion Time: 2/5/3
Sum/Square-Sum Completion Time: 9/33
Last Good Probe Time: 2010-06-21 15:33:09.2
Lost packet ratio: 0 %
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Receive response times: 3
RTD OverThresholds number: 0
Drop operation number:0
Operation timeout number:0
Connection fail number:0
RTT Stats errors number:0
6 NQA Configuration
265